CRM Mitchell1, Author at Reeves Complete Auto Center Inc

2016 Toyota Sequoia
Mileage
75,260
Service Date
4/12/2021
Services Performed
PERFORM OIL CHANGE, INSTALL NEW OIL FILTER, DRAIN PLUG GASKET AND FILL OIL TO SPEC. CHECK AND TOP OFF ALL FLUIDS. CHECK AND ADJUST TIRE PRESSURE TO SPEC PERFORM PREVENTATIVE MAINTENANCE INSPECTION RESET MAINTENANCE LIGHT IF ITS ON OR OFF INSTALL OIL CHANGE STICKER TO WINDSHIELD
GLENDA G. gave our service a 5 star review on 4/14/2021
2011 Chevrolet HHR
Mileage
69,343
Service Date
4/6/2021
Services Performed
PERFORM OIL CHANGE, INSTALL NEW OIL FILTER, DRAIN PLUG GASKET AND FILL OIL TO SPEC. CHECK AND TOP OFF ALL FLUIDS. CHECK AND ADJUST TIRE PRESSURE TO SPEC PERFORM PREVENTATIVE MAINTENANCE INSPECTION RESET MAINTENANCE LIGHT IF ITS ON OR OFF INSTALL OIL CHANGE STICKER TO WINDSHIELD
WHEEL HUB – Remove & Replace – Front,Both
You car's diagnostic system has detected a problem that is causing it not to perform to the standards set by the factory, and as a result the control module has turned on the check engine light. We are well equipped and trained to accurately diagnose and repair these problems. We can and will repair the car to factory standards,however, there may be more than one problem present. The engine management computer of your car is equipped with a sophisticated on-board diagnostic (OBD) system. When this system detects a problem it turns on the check engine light (CEL), sometimes called a multifunction indicator light (MIL). A problem in one of the monitored system is what turned on your CEL. Our technicians are highly trained and equipped with the latest state of the art diagnostic equipment, so that in most cases we will be able to diagnose and repair problems quickly and efficiently. There may be more than Problem Present even though Only one Trouble Code was Recorded in the Computer. The Computer Continually runs Various self Tests to ensure that All Systems are Working Normally. In the Event of a Failure some of these Self tests are Turned off Until the Original Problem is Fixed. This Means that until we Repair the Original Problem we may Not be Able to see Another Problem. This is More Likely to Occur if you have Been Driving for More Than Just a Few Days with The Mil Lite on.
LEON R. gave our service a 5 star review on 4/8/2021
2007 Nissan Xterra
Mileage
113,169
Service Date
4/2/2021
Services Performed
You car's diagnostic system has detected a problem that is causing it not to perform to the standards set by the factory, and as a result the control module has turned on the check engine light. We are well equipped and trained to accurately diagnose and repair these problems. We can and will repair the car to factory standards,however, there may be more than one problem present. The engine management computer of your car is equipped with a sophisticated on-board diagnostic (OBD) system. When this system detects a problem it turns on the check engine light (CEL), sometimes called a multifunction indicator light (MIL). A problem in one of the monitored system is what turned on your CEL. Our technicians are highly trained and equipped with the latest state of the art diagnostic equipment, so that in most cases we will be able to diagnose and repair problems quickly and efficiently. There may be more than Problem Present even though Only one Trouble Code was Recorded in the Computer. The Computer Continually runs Various self Tests to ensure that All Systems are Working Normally. In the Event of a Failure some of these Self tests are Turned off Until the Original Problem is Fixed. This Means that until we Repair the Original Problem we may Not be Able to see Another Problem. This is More Likely to Occur if you have Been Driving for More Than Just a Few Days with The Mil Lite on.
JOHN S. gave our service a 5 star review on 4/8/2021
2012 Nissan Frontier
Mileage
190,317
Service Date
3/31/2021
Services Performed
CHECK VEHICLE COMPLETELY & REPORT FINDINGS ON ATTACHED SHEET.
EVAPORATION CONTROL CANISTER – Remove & Replace
PERFORM OIL CHANGE, INSTALL NEW OIL FILTER, DRAIN PLUG GASKET AND FILL OIL TO SPEC. CHECK AND TOP OFF ALL FLUIDS. CHECK AND ADJUST TIRE PRESSURE TO SPEC PERFORM PREVENTATIVE MAINTENANCE INSPECTION RESET MAINTENANCE LIGHT IF ITS ON OR OFF INSTALL OIL CHANGE STICKER TO WINDSHIELD
You car's diagnostic system has detected a problem that is causing it not to perform to the standards set by the factory, and as a result the control module has turned on the check engine light. We are well equipped and trained to accurately diagnose and repair these problems. We can and will repair the car to factory standards,however, there may be more than one problem present. The engine management computer of your car is equipped with a sophisticated on-board diagnostic (OBD) system. When this system detects a problem it turns on the check engine light (CEL), sometimes called a multifunction indicator light (MIL). A problem in one of the monitored system is what turned on your CEL. Our technicians are highly trained and equipped with the latest state of the art diagnostic equipment, so that in most cases we will be able to diagnose and repair problems quickly and efficiently. There may be more than Problem Present even though Only one Trouble Code was Recorded in the Computer. The Computer Continually runs Various self Tests to ensure that All Systems are Working Normally. In the Event of a Failure some of these Self tests are Turned off Until the Original Problem is Fixed. This Means that until we Repair the Original Problem we may Not be Able to see Another Problem. This is More Likely to Occur if you have Been Driving for More Than Just a Few Days with The Mil Lite on.
LORN H. gave our service a 5 star review on 4/1/2021
2007 Lexus RX 400h
Mileage
228,312
Service Date
3/18/2021
Services Performed
CHECK VEHICLE COMPLETELY & REPORT FINDINGS ON ATTACHED SHEET.
PERFORM OIL CHANGE, INSTALL NEW OIL FILTER, DRAIN PLUG GASKET AND FILL OIL TO SPEC. CHECK AND TOP OFF ALL FLUIDS. CHECK AND ADJUST TIRE PRESSURE TO SPEC PERFORM PREVENTATIVE MAINTENANCE INSPECTION RESET MAINTENANCE LIGHT IF ITS ON OR OFF INSTALL OIL CHANGE STICKER TO WINDSHIELD
AMIR S. gave our service a 5 star review on 3/31/2021
2015 Acura RDX
Mileage
108,899
Service Date
3/17/2021
Services Performed
(Combination) – CRANKSHAFT GEAR OR SPROCKET – Remove & Replace
(Combination) – TIMING BELT IDLER PULLEY – Remove & Replace
(Combination) – TIMING BELT TENSIONER – Remove & Replace
(Combination) – WATER PUMP – Remove & Replace
CHECK VEHICLE COMPLETELY & REPORT FINDINGS ON ATTACHED SHEET.
DRAIN & FILL TRANS & REAR DIFF FLUIDS
TIMING BELT – Remove & Replace
TRANSAXLE OIL – Remove & Replace – In Line
VARIABLE VALVE TIMING OIL PRESSURE SWITCH – Remove & Replace
You car's diagnostic system has detected a problem that is causing it not to perform to the standards set by the factory, and as a result the control module has turned on the check engine light. We are well equipped and trained to accurately diagnose and repair these problems. We can and will repair the car to factory standards,however, there may be more than one problem present. The engine management computer of your car is equipped with a sophisticated on-board diagnostic (OBD) system. When this system detects a problem it turns on the check engine light (CEL), sometimes called a multifunction indicator light (MIL). A problem in one of the monitored system is what turned on your CEL. Our technicians are highly trained and equipped with the latest state of the art diagnostic equipment, so that in most cases we will be able to diagnose and repair problems quickly and efficiently. There may be more than Problem Present even though Only one Trouble Code was Recorded in the Computer. The Computer Continually runs Various self Tests to ensure that All Systems are Working Normally. In the Event of a Failure some of these Self tests are Turned off Until the Original Problem is Fixed. This Means that until we Repair the Original Problem we may Not be Able to see Another Problem. This is More Likely to Occur if you have Been Driving for More Than Just a Few Days with The Mil Lite on.
CHRIS M. gave our service a 5 star review on 3/17/2021
2007 Hyundai Santa Fe
Mileage
132,954
Service Date
3/11/2021
Services Performed
PERFORM OIL CHANGE, INSTALL NEW OIL FILTER, DRAIN PLUG GASKET AND FILL OIL TO SPEC. CHECK AND TOP OFF ALL FLUIDS. CHECK AND ADJUST TIRE PRESSURE TO SPEC PERFORM PREVENTATIVE MAINTENANCE INSPECTION RESET MAINTENANCE LIGHT IF ITS ON OR OFF INSTALL OIL CHANGE STICKER TO WINDSHIELD
Remove All four wheels to inspect brake condition. Inspect entire system for leaks. Lining remaining is: Front (%) Rear (%)
JOHN R. gave our service a 5 star review on 3/11/2021
2014 Jeep Grand Cherokee
Mileage
106,964
Service Date
3/9/2021
Services Performed
CHECK ON ADJUSTING E BRAKE AND ZIP TIE ECU CONNECTOR
CLEAN & ADJUST REAR BRAKES AS NEEDED
PASSENGER SIDE
TRANSMISSION OIL PAN GASKET &/OR FILTER – Remove & Replace – V6,3.6L Eng – [Includes: Additional time for use of scan tool to perform this procedure.]
Unplug and Cut Off the Old Connector, Strip the End, Then Cut the end of the wire cleanly, and then place the wire with 3/4 inch of it sticking out of the stripper. Then pull the wire out, removing 1/4 inch of the insulator. Twist the end of the wire. Next crimp the New Connector, Insert the stripped end of the wire into the connector until it bottoms out. Then, place the connector about 1/8 of an inch from the wire end of the connector into the crimp and crimp together. Plug the fixed connector back in
JOHN H. gave our service a 5 star review on 3/11/2021
2015 Toyota Sienna
Mileage
64,991
Service Date
3/5/2021
Services Performed
Remove All four wheels to inspect brake condition. Inspect entire system for leaks. Lining remaining is: Front (%) Rear (%)
Replace front brake pad linings and machine front brake disc rotors on vehicle with new state of the art on car brake lathe, THAT WILL PERFORM 0 TOLERANCE HIGH PRECISION CUTTING for much better accuracy. Clean and repack wheel bearings if equipped. Clean and lubricate brake calipers and slide mechanisms. Check and fill brake fluid. Bleed air from system. Road test vehicle. PLEASE GIVE BRAKES ABOUT 50 TO 100 MILES TO BREAK IN……..THANKS DAVE
SHIMMY IN BRAKE PEDAL
MERVIL T. gave our service a 5 star review on 3/6/2021
2014 Ford Focus
Mileage
95,817
Service Date
2/24/2021
Services Performed
CLEAN & ADJUST REAR BRAKES AS NEEDED
MOUNT & BALANCE TIRE/TIRES
PERFORM OIL CHANGE, INSTALL NEW OIL FILTER, DRAIN PLUG GASKET AND FILL OIL TO SPEC. CHECK AND TOP OFF ALL FLUIDS. CHECK AND ADJUST TIRE PRESSURE TO SPEC PERFORM PREVENTATIVE MAINTENANCE INSPECTION RESET MAINTENANCE LIGHT IF ITS ON OR OFF INSTALL OIL CHANGE STICKER TO WINDSHIELD
Remove All four wheels to inspect brake condition. Inspect entire system for leaks. Lining remaining is: Front (%) Rear (%)
REPLACE ALL LUG NUTS
JOSH I. gave our service a 5 star review on 2/25/2021

CRM Mitchell1

We Service and Repair all CRM Mitchell1 cars