Nissan Archives - Reeves Complete Auto Center Inc

2012 Nissan Rogue
Mileage
183,439
Service Date
3/8/2024
Services Performed
HAD ROUGH IDLE, STALLED, RESTARTED AND COULD NOT GO OVER 15 MPH
SPARK PLUGS – Remove & Replace
RADIATOR – Remove & Replace
ROBERT G. gave our service a 5 star review on 3/9/2024
2019 Nissan Murano
Mileage
101,764
Service Date
2/28/2024
Services Performed
PERFORM OIL CHANGE, INSTALL NEW OIL FILTER, DRAIN PLUG GASKET AND FILL OIL TO SPEC. CHECK AND TOP OFF ALL FLUIDS, EXCLUDING BRAKE FLUID CHECK AND ADJUST TIRE PRESSURE TO SPEC RESET MAINTENANCE LIGHT IF ITS ON OR OFF INSTALL OIL CHANGE STICKER TO WINDSHIELD
Remove All four wheels to inspect brake condition. Inspect entire system for leaks. Lining remaining is: Front (%) Rear (%)
SPARK PLUGS – Remove & Replace – [Includes: R&I Induction Manifold.]
Replace front brake pad linings and replace front brake disc rotors. Clean and repack wheel bearings if equipped. Clean and lubricate brake calipers and slide mechanisms. Check and fill brake fluid. Bleed air from system. Road test vehicle. PLEASE GIVE BRAKES ABOUT 50 TO 100 MILES TO BREAK IN
TERESA G. gave our service a 5 star review on 2/28/2024
2007 Nissan Xterra
Mileage
125,779
Service Date
6/2/2023
Services Performed
CHECK VEHICLE IS STALLING
CAMSHAFT POSITION SENSOR – Remove & Replace – w/Induction Manifold,Removal,Both – [Includes: R&I Induction Manifold.]
CRANKSHAFT POSITION SENSOR – Remove & Replace
SPARK PLUG – Remove & Replace
JOHN S. gave our service a 5 star review on 6/8/2023
2013 Nissan Juke
Mileage
109,480
Service Date
3/24/2023
Services Performed
You vehicle's diagnostic system has detected a problem that is causing it not to perform to factory standards, resulting in the control module turning on the check engine light (CEL). We are well equipped & trained to accurately diagnose & repair these problems. We can & will repair the car to factory standards, however, there may be more than one problem present. The engine management computer of your car is equipped with a sophisticated on-board diagnostic (OBD) system. When this system detects a problem it turns on the CEL. A problem in one of the monitored system is what turned on your CEL. Our technicians are highly trained & equipped with the latest state of the art diagnostic equipment, so that in most cases we will be able to diagnose & repair problems quickly and efficiently. There may be more than one problem present even though only one trouble code was recorded in the module. The module continually runs various self tests to ensure that all systems are working normally. In the event of a failure some of these self tests are turned off until the original problem is fixed. This means that until we repair the original problem we may not be able to see other problems. This is likely to occur if you have been driving with the CEL for multiple days.
Diagnose air conditioning system
PERFORM OIL CHANGE, INSTALL NEW OIL FILTER, DRAIN PLUG GASKET AND FILL OIL TO SPEC. CHECK AND TOP OFF ALL FLUIDS. CHECK AND ADJUST TIRE PRESSURE TO SPEC RESET MAINTENANCE LIGHT IF ITS ON OR OFF INSTALL OIL CHANGE STICKER TO WINDSHIELD
Service air conditioner. Check condition of all belts and lines. Evacuate and recharge with R-134. Test system performance. SPECS AFTER RECHARGE – LOW SIDE – ()PSI HIGH SIDE – ()PSI CENTER VENT TEMP – ()DEGREES
MASS AIR FLOW SENSOR – Remove & Replace
AIR FILTER – Remove & Replace
DOUG L. gave our service a 5 star review on 4/10/2023
2012 Nissan Sentra
Mileage
43,896
Service Date
8/8/2022
Services Performed
PERFORM OIL CHANGE, INSTALL NEW OIL FILTER, DRAIN PLUG GASKET AND FILL OIL TO SPEC. CHECK AND TOP OFF ALL FLUIDS. CHECK AND ADJUST TIRE PRESSURE TO SPEC PERFORM PREVENTATIVE MAINTENANCE INSPECTION RESET MAINTENANCE LIGHT IF ITS ON OR OFF INSTALL OIL CHANGE STICKER TO WINDSHIELD
CHECK VEHICLE COMPLETELY & REPORT FINDINGS ON ATTACHED SHEET.
CLEOPATRA R. gave our service a 5 star review on 8/9/2022
2016 Nissan Altima
Mileage
94,611
Service Date
4/29/2022
Services Performed
PERFORM OIL CHANGE, INSTALL NEW OIL FILTER, DRAIN PLUG GASKET AND FILL OIL TO SPEC. CHECK AND TOP OFF ALL FLUIDS. CHECK AND ADJUST TIRE PRESSURE TO SPEC PERFORM PREVENTATIVE MAINTENANCE INSPECTION RESET MAINTENANCE LIGHT IF ITS ON OR OFF INSTALL OIL CHANGE STICKER TO WINDSHIELD
ROTATE TIRES TO CUSTOMER SPECIFICATIONS AND CHECK & ADJUST AIR PRESSURE
AUSTIN W. gave our service a 5 star review on 5/10/2022
2007 Nissan Altima
Mileage
149,630
Service Date
4/18/2022
Services Performed
You vehicle's diagnostic system has detected a problem that is causing it not to perform to factory standards, resulting in the control module turning on the check engine light (CEL). We are well equipped & trained to accurately diagnose & repair these problems. We can & will repair the car to factory standards, however, there may be more than one problem present. The engine management computer of your car is equipped with a sophisticated on-board diagnostic (OBD) system. When this system detects a problem it turns on the CEL. A problem in one of the monitored system is what turned on your CEL. Our technicians are highly trained & equipped with the latest state of the art diagnostic equipment, so that in most cases we will be able to diagnose & repair problems quickly and efficiently. There may be more than one problem present even though only one trouble code was recorded in the module. The module continually runs various self tests to ensure that all systems are working normally. In the event of a failure some of these self tests are turned off until the original problem is fixed. This means that until we repair the original problem we may not be able to see other problems. This is likely to occur if you have been driving with the CEL for multiple days.
PERFORM OIL CHANGE, INSTALL NEW OIL FILTER, DRAIN PLUG GASKET AND FILL OIL TO SPEC. CHECK AND TOP OFF ALL FLUIDS. CHECK AND ADJUST TIRE PRESSURE TO SPEC PERFORM PREVENTATIVE MAINTENANCE INSPECTION RESET MAINTENANCE LIGHT IF ITS ON OR OFF INSTALL OIL CHANGE STICKER TO WINDSHIELD
ROTATE TIRES TO CUSTOMER SPECIFICATIONS AND CHECK & ADJUST AIR PRESSURE
MIKALA T. gave our service a 5 star review on 4/21/2022
2019 Nissan Murano
Mileage
57,291
Service Date
12/2/2021
Services Performed
PERFORM OIL CHANGE, INSTALL NEW OIL FILTER, DRAIN PLUG GASKET AND FILL OIL TO SPEC. CHECK AND TOP OFF ALL FLUIDS. CHECK AND ADJUST TIRE PRESSURE TO SPEC PERFORM PREVENTATIVE MAINTENANCE INSPECTION RESET MAINTENANCE LIGHT IF ITS ON OR OFF INSTALL OIL CHANGE STICKER TO WINDSHIELD
CHECK VEHICLE COMPLETELY & REPORT FINDINGS ON ATTACHED SHEET.
Replace rear brake pad linings and replace rear brake disc rotors. Clean and repack wheel bearings if equipped. Clean and lubricate brake calipers and slide mechanisms. Check and fill brake fluid. Bleed air from system. Road test vehicle. PLEASE GIVE BRAKES ABOUT 50 TO 100 MILES TO BREAK IN……..THANKS DAVE
TERESA G. gave our service a 5 star review on 12/2/2021
2005 Nissan Altima
Mileage
134,540
Service Date
7/23/2021
Services Performed
CHECK VEHICLE COMPLETELY & REPORT FINDINGS ON ATTACHED SHEET.
ROAD TEST & CHECK FOR SLIPPING TRANSMISSION
TIE ROD &/OR END – Remove & Replace – Outer,Both – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some models. If
2 WHEEL ALIGNMENT
BARBARA M. gave our service a 5 star review on 7/26/2021
2007 Nissan Xterra
Mileage
113,169
Service Date
4/2/2021
Services Performed
You car's diagnostic system has detected a problem that is causing it not to perform to the standards set by the factory, and as a result the control module has turned on the check engine light. We are well equipped and trained to accurately diagnose and repair these problems. We can and will repair the car to factory standards,however, there may be more than one problem present. The engine management computer of your car is equipped with a sophisticated on-board diagnostic (OBD) system. When this system detects a problem it turns on the check engine light (CEL), sometimes called a multifunction indicator light (MIL). A problem in one of the monitored system is what turned on your CEL. Our technicians are highly trained and equipped with the latest state of the art diagnostic equipment, so that in most cases we will be able to diagnose and repair problems quickly and efficiently. There may be more than Problem Present even though Only one Trouble Code was Recorded in the Computer. The Computer Continually runs Various self Tests to ensure that All Systems are Working Normally. In the Event of a Failure some of these Self tests are Turned off Until the Original Problem is Fixed. This Means that until we Repair the Original Problem we may Not be Able to see Another Problem. This is More Likely to Occur if you have Been Driving for More Than Just a Few Days with The Mil Lite on.
JOHN S. gave our service a 5 star review on 4/8/2021

Nissan

We Service and Repair all Nissan cars