CRM Mitchell1

Home / Archives for CRM Mitchell1 / Page 19

We Service and Repair all CRM Mitchell1 cars

  • 2005 Hyundai Tucson

    Hyundai Tucson
    Mileage
    124,889
    Service Date
    12/29/2020
    Services Performed
    • AXLE SHAFT – Remove & Replace – Both – [NOTE: For Independent Suspension Type Axles, this operation consists of removal and installation, dissassembly and reassembly of the Axle Shaft Assembly and replacement of the Axle Shaft.]
    • CHECK FRT END BUSHINGS
    • CONTROL ARM – Remove & Replace – Lower,Both – [DOES NOT include alignment.]
    • Replace front brake pad linings and replace front brake disc rotors. Clean and repack wheel bearings if equipped. Clean and lubricate brake calipers and slide mechanisms. Check and fill brake fluid. Bleed air from system. Road test vehicle. PLEASE GIVE BRAKES ABOUT 50 TO 100 MILES TO BREAK IN……..THANKS DAVE
    • 4 WHEEL ALIGNMENT
     
    DAVE R. gave our service a 5 star review on 12/29/2020
  • 2004 Chrysler Town & Country

    Chrysler Town & Country
    Mileage
    178,084
    Service Date
    12/17/2020
    Services Performed
    • CHECK FOR FUEL SMELL AND RUMBLE WHEN IN GEAR
    • ENGINE OR TRANSMISSION MOUNT – Remove & Replace – Engine,Left Side
    • ENGINE OR TRANSMISSION MOUNT – Remove & Replace – Engine,Rear
    • ENGINE OR TRANSMISSION MOUNT – Remove & Replace – Engine,Right Side
    • FUEL TANK – Remove & Replace – All Applicable Models
     
    TIM W. gave our service a 5 star review on 12/18/2020
  • 2014 Toyota Camry

    Toyota Camry
    Mileage
    48,981
    Service Date
    12/15/2020
    Services Performed
    • PERFORM OIL CHANGE, INSTALL NEW OIL FILTER, DRAIN PLUG GASKET AND FILL OIL TO SPEC. CHECK AND TOP OFF ALL FLUIDS. CHECK AND ADJUST TIRE PRESSURE TO SPEC PERFORM PREVENTATIVE MAINTENANCE INSPECTION RESET MAINTENANCE LIGHT IF ITS ON OR OFF INSTALL OIL CHANGE STICKER TO WINDSHIELD
     
    LARRY M. gave our service a 5 star review on 12/30/2020
  • 2015 Ford Explorer

    Ford Explorer
    Mileage
    96,946
    Service Date
    12/11/2020
    Services Performed
    • CATALYTIC CONVERTER – Remove & Replace – V6,Normally Aspirated,FWD Left Side
    • CHECK VEHICLE COMPLETELY & REPORT FINDINGS ON ATTACHED SHEET.
    • Inspect hoses and clamps. Pressure test cooling system. Flush engine, radiator, and heater core in both directions. Bring antifreeze to -35 degrees. PH balance coolant to between 9.8 to 10.5. Check thermostat and electric cooling fan operation. Chec
    • SPARK PLUGS – Remove & Replace – V6,Normally Aspirated
    • You car's diagnostic system has detected a problem that is causing it not to perform to the standards set by the factory, and as a result the control module has turned on the check engine light. We are well equipped and trained to accurately diagnose and repair these problems. We can and will repair the car to factory standards,however, there may be more than one problem present. The engine management computer of your car is equipped with a sophisticated on-board diagnostic (OBD) system. When this system detects a problem it turns on the check engine light (CEL), sometimes called a multifunction indicator light (MIL). A problem in one of the monitored system is what turned on your CEL. Our technicians are highly trained and equipped with the latest state of the art diagnostic equipment, so that in most cases we will be able to diagnose and repair problems quickly and efficiently. There may be more than Problem Present even though Only one Trouble Code was Recorded in the Computer. The Computer Continually runs Various self Tests to ensure that All Systems are Working Normally. In the Event of a Failure some of these Self tests are Turned off Until the Original Problem is Fixed. This Means that until we Repair the Original Problem we may Not be Able to see Another Problem. This is More Likely to Occur if you have Been Driving for More Than Just a Few Days with The Mil Lite on.
     
    RUSSELL A. gave our service a 5 star review on 12/30/2020