Services Performed
- You vehicle's diagnostic system has detected a problem that is causing it not to perform to factory standards, resulting in the control module turning on the check engine light (CEL). We are well equipped & trained to accurately diagnose & repair these problems. We can & will repair the car to factory standards, however, there may be more than one problem present. The engine management computer of your car is equipped with a sophisticated on-board diagnostic (OBD) system. When this system detects a problem it turns on the CEL. A problem in one of the monitored system is what turned on your CEL. Our technicians are highly trained & equipped with the latest state of the art diagnostic equipment, so that in most cases we will be able to diagnose & repair problems quickly and efficiently. There may be more than one problem present even though only one trouble code was recorded in the module. The module continually runs various self tests to ensure that all systems are working normally. In the event of a failure some of these self tests are turned off until the original problem is fixed. This means that until we repair the original problem we may not be able to see other problems. This is likely to occur if you have been driving with the CEL for multiple days.
- CHECK VEHICLE COMPLETELY & REPORT FINDINGS ON ATTACHED SHEET.
- FLUSH COOLANT AND TRANSMISSION CHECK ALL FLUIDS
- MASS AIR FLOW SENSOR – Remove & Replace – V6
- SPARK PLUGS – Remove & Replace – V6
- Clean gum and soft carbon deposit from fuel delivery components and inside combustion chamber. Install chemical in gas tank . Perform complete fuel pressure and volume test. Road test vehicle.
- Replace front brake pad linings and machine front brake disc rotors on vehicle with new state of the art on car brake lathe, THAT WILL PERFORM 0 TOLERANCE HIGH PRECISION CUTTING for much better accuracy. Clean and repack wheel bearings if equipped. Clean and lubricate brake calipers and slide mechanisms. Check and fill brake fluid. Bleed air from system. Road test vehicle. PLEASE GIVE BRAKES ABOUT 50 TO 100 MILES TO BREAK IN
- LICENSE PLATE LIGHT & LEFT REVERSE LIGHT BULBS – Remove & Replace
- Inspect hoses and clamps. Pressure test cooling system. Flush engine, radiator, and heater core in both directions. Bring antifreeze to -35 degrees. PH balance coolant to between 9.8 to 10.5. Check thermostat and electric cooling fan operation. Chec
- TRANSMISSION FLUID – Drain & Refill
WILLIAM E. gave our service a 5 star review on 6/21/2024
