Call (661) 252-1400

Go to…

Toyota

Home / Toyota / Page 2

We Service and Repair all Toyota cars

  • 2014 Toyota Highlander

    Toyota Highlander
    Mileage
    158,697
    Service Date
    5/3/2024
    Services Performed
    • CHECK SUSPENSION DEALER RECOMMEND A FEW COMPONENTS CUSTOMER ONLY REMEMBERS CONTROL ARMS
     
    BARLAAN R. gave our service a 5 star review on 5/8/2024

  • 2004 Toyota 4Runner

    Toyota 4Runner
    Mileage
    166,432
    Service Date
    4/16/2024
    Services Performed
    • Found code C1336 ZERO POINT CALIBRATION OF DECELERATION SENSOR UNDONE. Reset memory in abs module and performed zero point calibration, code cleared. Test drove vehicle and abs & trac light no longer illuminated.
     
    MONIKA B. gave our service a 5 star review on 5/6/2024

  • 2010 Toyota Camry

    Toyota Camry
    Mileage
    90,159
    Service Date
    3/20/2024
    Services Performed
    • SPLASH SHIELD – Remove & Replace
     
    RONY A. gave our service a 5 star review on 3/22/2024

  • 2021 Toyota Tacoma

    Toyota Tacoma
    Mileage
    51,316
    Service Date
    3/21/2024
    Services Performed
    • PERFORM OIL CHANGE, INSTALL NEW OIL FILTER, DRAIN PLUG GASKET AND FILL OIL TO SPEC. CHECK AND TOP OFF ALL FLUIDS, EXCLUDING BRAKE FLUID CHECK AND ADJUST TIRE PRESSURE TO SPEC RESET MAINTENANCE LIGHT IF ITS ON OR OFF INSTALL OIL CHANGE STICKER TO WINDSHIELD
    • ROTATE TIRES TO CUSTOMER SPECIFICATIONS AND CHECK & ADJUST AIR PRESSURE
    • Remove All four wheels to inspect brake condition. Inspect entire system for leaks. Lining remaining is: Front (40%) Rear (70%)
     
    DARIN S. gave our service a 5 star review on 3/21/2024

  • 2016 Toyota Sequoia

    Toyota Sequoia
    Mileage
    103,143
    Service Date
    2/23/2024
    Services Performed
    • PERFORM OIL CHANGE, INSTALL NEW OIL FILTER, DRAIN PLUG GASKET AND FILL OIL TO SPEC. CHECK AND TOP OFF ALL FLUIDS, EXCLUDING BRAKE FLUID CHECK AND ADJUST TIRE PRESSURE TO SPEC RESET MAINTENANCE LIGHT IF ITS ON OR OFF INSTALL OIL CHANGE STICKER TO WINDSHIELD
     
    GLENDA G. gave our service a 5 star review on 2/24/2024

  • 2005 Toyota Highlander

    Toyota Highlander
    Mileage
    207,023
    Service Date
    10/5/2023
    Services Performed
    • You vehicle's diagnostic system has detected a problem that is causing it not to perform to factory standards, resulting in the control module turning on the check engine light (CEL). We are well equipped & trained to accurately diagnose & repair these problems. We can & will repair the car to factory standards, however, there may be more than one problem present. The engine management computer of your car is equipped with a sophisticated on-board diagnostic (OBD) system. When this system detects a problem it turns on the CEL. A problem in one of the monitored system is what turned on your CEL. Our technicians are highly trained & equipped with the latest state of the art diagnostic equipment, so that in most cases we will be able to diagnose & repair problems quickly and efficiently. There may be more than one problem present even though only one trouble code was recorded in the module. The module continually runs various self tests to ensure that all systems are working normally. In the event of a failure some of these self tests are turned off until the original problem is fixed. This means that until we repair the original problem we may not be able to see other problems. This is likely to occur if you have been driving with the CEL for multiple days.
    • CATALYTIC CONVERTER – Remove & Replace – V6,FWD Exhaust Manifold,Both – [Includes: Replace Thermo Sensor.]
     
    RYAN T. gave our service a 5 star review on 10/6/2023

  • 2012 Toyota Tacoma

    Toyota Tacoma
    Mileage
    80,401
    Service Date
    10/5/2023
    Services Performed
    • CHECK VEHICLE COMPLETELY & REPORT FINDINGS ON ATTACHED SHEET.
    • CHECK TRACTION CONTROL BUTTON IS STUCK, CHECK LEAF SPRINGS, CUSTOMER STATES THEY ARE MISALIGNED & CHECK FOR CLINKING NOISE IN FRONT END
    • PERFORM OIL CHANGE, INSTALL NEW OIL FILTER, DRAIN PLUG GASKET AND FILL OIL TO SPEC. CHECK AND TOP OFF ALL FLUIDS, EXCLUDING BRAKE FLUID CHECK AND ADJUST TIRE PRESSURE TO SPEC RESET MAINTENANCE LIGHT IF ITS ON OR OFF INSTALL OIL CHANGE STICKER TO WINDSHIELD
    • AIR FILTER – Remove & Replace
    • CABIN AIR FILTER – Remove & Replace
    • DIFFERENTIAL FLUID – Drain & Refill – 4WD Front Axle,w/Skid Plate
     
    PATRICK P. gave our service a 5 star review on 10/6/2023

  • 2005 Toyota Matrix

    Toyota Matrix
    Mileage
    198,721
    Service Date
    9/11/2023
    Services Performed
    • PERFORM OIL CHANGE, INSTALL NEW OIL FILTER, DRAIN PLUG GASKET AND FILL OIL TO SPEC. CHECK AND TOP OFF ALL FLUIDS, EXCLUDING BRAKE FLUID CHECK AND ADJUST TIRE PRESSURE TO SPEC RESET MAINTENANCE LIGHT IF ITS ON OR OFF INSTALL OIL CHANGE STICKER TO WINDSHIELD
     
    FRANK B. gave our service a 5 star review on 9/13/2023

  • 2014 Toyota Camry

    Toyota Camry
    Mileage
    109,728
    Service Date
    8/14/2023
    Services Performed
    • PERFORM OIL CHANGE, INSTALL NEW OIL FILTER, DRAIN PLUG GASKET AND FILL OIL TO SPEC. CHECK AND TOP OFF ALL FLUIDS, EXCLUDING BRAKE FLUID CHECK AND ADJUST TIRE PRESSURE TO SPEC RESET MAINTENANCE LIGHT IF ITS ON OR OFF INSTALL OIL CHANGE STICKER TO WINDSHIELD
    • CONTROL ARM – Remove & Replace – Gas,In-Line4 Lower,Both – [DOES NOT include alignment.]
    • ALIGN
     
    FRANK J. gave our service a 5 star review on 8/16/2023

  • 2006 Toyota Prius

    Toyota Prius
    Mileage
    251,563
    Service Date
    7/11/2023
    Services Performed
    • You vehicle's diagnostic system has detected a problem that is causing it not to perform to factory standards, resulting in the control module turning on the check engine light (CEL). We are well equipped & trained to accurately diagnose & repair these problems. We can & will repair the car to factory standards, however, there may be more than one problem present. The engine management computer of your car is equipped with a sophisticated on-board diagnostic (OBD) system. When this system detects a problem it turns on the CEL. A problem in one of the monitored system is what turned on your CEL. Our technicians are highly trained & equipped with the latest state of the art diagnostic equipment, so that in most cases we will be able to diagnose & repair problems quickly and efficiently. There may be more than one problem present even though only one trouble code was recorded in the module. The module continually runs various self tests to ensure that all systems are working normally. In the event of a failure some of these self tests are turned off until the original problem is fixed. This means that until we repair the original problem we may not be able to see other problems. This is likely to occur if you have been driving with the CEL for multiple days.
    • COOLANT FLOW CONTROL VALVE – Remove & Replace – Flow Control Valve
    • COOLANT – Drain & Refill
     
    RYAN C. gave our service a 5 star review on 7/14/2023